What is the command to check the current status of hyper-threading?
A. fw ctl get int cphwd_hyper_status
B. fw ctl multik stat
C. cat/proc/hyperstats
D. cat/proc/smt_status
What process(es) should be checked if there is high I/O and you suspect it may be related to the Antivirus Software Blade?
A. avsp
B. dlpu and rad processes
C. cpta
D. cpm and fwm
Where do Protocol parsers register themselves for IPS?
A. Passive Streaming Library
B. Other handlers register to Protocol parser
C. Protections database
D. Context Management Infrastructure
Which Check Point daemon, if it stops responding or goes down, results in connections from the SmartConsole to the Management Server failing?
A. SMSD
B. CPTA
C. CPM
D. FWD
Which kernel table stores information about NAT connections?
A. connections
B. tab_nat_conn
C. xlate
D. fwx_alloc
For organizations with existing IPv4 networks who wish to move to IPv6, which of the following is a Transition Mechanism that can be used?
A. ipv4 to ipv6 Triple Stack
B. Hex to Dec translation
C. 6 in 4 Tunneling
D. NAT-T to NAT6sec
When troubleshooting static NAT, you would follow all the steps below, EXCEPT:
A. Verify NAT configuration
B. Debug NAT
C. Run "fw tab -t fwx_alloc"
D. Run "fw ctl arp" command
What is a primary advantage of using the fw monitor tool?
A. It always captures all packets hitting the physical layer
B. It is menu-driven, making it easy to configure
C. It has no negative impact on firewall performance
D. It can capture packets in various positions as they move through the firewall
You have configured SecureXL NAT templates with the "fw ctl set" command. You check configuration and ensure that NAT templates were enabled. After an accidental reboot, you issue "fwaccel stat" and noticed that NAT Templates are not enabled. You need to permanently enable SecureXL NAT templates. What should you do?
A. Set NAT Templates with "fwaccel templates NAT" command and save configuration with "save config"
B. Enable NAT Templates again with "fw ctl set" and save configuration with "save config"
C. Enable NAT Templates again with "fw ctl set" and edit appropriate parameters in $FWDIR/boot/ modules/fwkern.conf
D. Edit appropriate parameters in $FWDIR/boot/modules/fwkern.conf
How would you disable CPM debug?
A. Run fw debug cpm off TDERROR_ALL_ALL=0
B. Delete $FWDIR/log/tdlog.cpm file
C. Set the severity level to INFO and run cpm_debug.sh –r
D. Delete $FWDIR/log/fwm.elg file
