DRAG DROP
Drag and drop the networking parameters from the left on to the correct values on the right.
Select and Place:
Refer to the exhibit.
A network engineer configures the CCNA WLAN so that clients must reauthenticate hourly and to limit the number of simultaneous connections to the WLAN to 10. Which two actions complete this configuration? (Choose two.)
A. Enable the Wi-Fi Direct Clients Policy option
B. Enable the Enable Session Timeout option and set the value to 3600.
C. Enable the Client Exclusion option and set the value to 3600.
D. Set the Maximum Allowed Clients value to 10.
E. Set the Maximum Allowed Clients Per AP Radio value to 10.
What is represented in line 4 within this JSON schema?
A. object
B. array
C. key
D. value
What is represented by the word "IDS" within this JSON schema?
A. object
B. value
C. array
D. key
What is represented beginning with line 1 and ending with line 5 within this JSON schema?
A. key
B. object
C. array
D. value
Which protocol is used for secure remote CLI access?
A. HTTPS
B. HTTP
C. Telnet
D. SSH
What are two benefits of using the PortFast feature? (Choose two)
A. Enabled interfaces are automatically placed in listening state
B. Enabled interfaces come up and move to the forwarding state immediately
C. Enabled interfaces never generate topology change notifications.
D. Enabled interfaces that move to the learning state generate switch topology change notifications
E. Enabled interfaces wait 50 seconds before they move to the forwarding state
An engineer must configure an OSPF neighbor relationship between router R1 and R3 The authentication configuration has been configured and the connecting interfaces are in the same 192.168 1.0/30 sublet. What are the next two steps to complete the configuration? (Choose two.)
A. configure the hello and dead timers to match on both sides
B. configure the same process ID for the router OSPF process
C. configure the same router ID on both routing processes
D. Configure the interfaces as OSPF active on both sides.
E. configure both interfaces with the same area ID
What is a DHCP client?
A. a workstation that requests a domain name associated with its IP address
B. a host that is configured to request an IP address automatically
C. a server that dynamically assigns IP addresses to hosts.
D. a router that statically assigns IP addresses to hosts.
R1 has learned route 192.168.12.0/24 via IS-IS, OSPF, RIP, and Internal EIGRP. Under normal operating conditions, which routing protocol is installed in the routing table?
A. IS-IS
B. Internal EIGRP
C. RIP
D. OSPF
