New Syslog servers have been deployed in an organization. The BIG-IP Administrator must reconfigure the BIG-IP system to send log messages to these servers.
In which location in the Configuration Utility can the BIG-IP Administrator make the needed configuration changes to accomplish this?
A. System > Logs > Configuration
B. System > Configuration > Local Traffic
C. System > Logs > Audit
D. System > Configuration > Device
Which two can be a part of a virtual server's definition? (Choose two.)
A. rule(s)
B. pool(s)
C. monitor(s)
D. node address(es)
E. loadbalancing method(s)
What should the 816-IP Administrator provide when opening a new ticket with F5 Support?
A. bigip.license file
B. QKViewfile
C. Device root password
D. SSL private keys
Assume a client's traffic is being processed only by a NAT; no SNAT or virtual server processing takes place. Also assume that the NAT definition specifies a NAT address and an origin address while all other settings are left at their defaults. If a client were to initiate traffic to the NAT address, what changes, if any, would take place when the BIG-IP processes such packets?
A. The source address would not change, but the destination address would be translated to the origin address.
B. The destination address would not change, but the source address would be translated to the origin address.
C. The source address would not change, but the destination address would be translated to the NAT's address.
D. The destination address would not change, but the source address would be translated to the NAT's address.
A set of servers is used for an FTP application as well as an HTTP website via separate BIG-IP Pools. The server support team reports that some servers are receiving a lot more traffic than others. Which Load Balancing Method should the BIG-IP Administrator apply to even out the connection count?
A. Ratio (Member)
B. Least Connections (Member)
C. Least Connections (Node)
D. Ratio (Node)
A BIG-IP Administrator needs to configure the BIG-IP system to perform load balancing for FTP servers running passive mode FTP.
How should the administrator configure the Virtual Server to perform this load balancing?
A. A Standard Virtual Server + FTP profile
B. A Forwarding Virtual Server
C. A Performance Layer 4 Virtual Server + FTP profile
D. A Message Routing Virtual Server
Users report that traffic is negatively affected every time a BIG-IP device fails over. The traffic becomes stabilized after a few minutes.
What should the BIG-IP Administrator do to reduce the impact of future failovers?
A. Enable Failover Multicast Configuration
B. Set up Failover Method to HA Order
C. Configure MAC Masquerade
D. Configure a global SNAT Listener
The BIG-IP Administrator configures an HTTP monitor with a specific receive string. The status is marked 'down'.
Which tool should the administrator use to identify the problem?
A. Ping
B. Health
C. tcpdump
D. ifconfig
Which action will take place when a failover trigger is detected by the active system?
A. The active device will take the action specified for the failure.
B. The standby device also detects the failure and assumes the active role.
C. The active device will wait for all connections to terminate and then failover.
D. The standby device will begin processing virtual servers that have failed, but the active device will continue servicing the functional virtual servers.
Which statement is true concerning iRule events?
A. All iRule events relate to HTTP processes.
B. All client traffic has data that could be used to trigger iRule events.
C. All iRule events are appropriate at any point in the clientserver communication.
D. If an iRule references an event that doesn't occur during the client's communication, the client's connection will be terminated prematurely.
