Which CLI command should be executed on a KVM hypervisor to retrieve the VM interface UUID?
A. virsh dumpxml
B. virsh get-interface
C. virsh show
D. virsh list-interface
Which CLI command shows syslog on NSX Manager?
A. show log manager follow
B. get log-file auth.log
C. get log-file syslog
D. /var/log/sysloq/syslog.log
Which tool could be used to inspect the path of a packet in the data plane?
A. Port Connection
B. Port Mirroring Session
C. Netflow
D. Traceflow
A customer has a network where BGP has been enabled and the BGP neighbor is configured on the Tier-0 Gateway. A NSX-T Data Center administrator used the get logical-routers command to retrieve this information: Which two commands must be executed to check BGP neighbor status? (Choose two.)
A. vrf 3
B. vrf 1
C. vrf 4
D. sa-nsxedge-01(tier1_sr)> get bgp neighbor
E. sa-nsxedge-01(tier0_sr)> get bgp neighbor
F. sa-nsxedge-01(tier0_dr)> get bgp neighbor
Which two logical router components span across all transport nodes? (Choose two.)
A. DISTRIBUTED_ROUTER_TIER0
B. SERVICE_ROUTER_TIER0
C. TIER0_DISTRIBUTED_ROUTER
D. DISTRIBUTED_ROUTER_TIER1
E. SERVICE_ROUTER_TIER1
Which NSX CLI command is used to check the GENEVE tunnel status on ESXi transport node?
A. get host-switch
B. get transport-node tunnel status
C. get host-switch
D. get transport-node tunnel state
Which network virtualization technologies can be used with an Ethernet VPN (EVPN) deployment in NSX-T Data Center? (Choose two.)
A. Virtual Extensible Local Area Network (VXLAN)
B. Multiprotocol Border Gateway Protocol (MP-BGP)
C. Open Shortest Path First (OSPF)
D. Multiprotocol Label Switching (MPLS)
E. Virtual Routing and Forwarding (VRF)
Which profile must be attached to the ESXi cluster to prepare the host for NSX-T Data Center?
A. Transport Node Profile
B. Uplink Profile
C. Switching Profile
D. Host Profile
An NSX administrator is reviewing syslog and notices that Distributed Firewall Rules hit counts are not being logged. What could cause this issue?
A. Syslog is not configured on the NSX Manager
B. Distributed Firewall Rule logging is not enabled
C. Zero Trust Security is not enabled
D. Syslog is not configured on the ESXi transport node
Which CLI command is used to disable SSH timeout on NSX Manger and NSX Edge nodes?
A. set cli ssh timeout 0
B. set esxcli ssh session off
C. set cli-timeout 0
D. nsxcli ssh session on
