Vcehome > Cisco > CCNP Enterprise > 300-410 > 300-410 Online Practice Questions and Answers

300-410 Online Practice Questions and Answers

Questions 4

Refer to the exhibits.

Phase-3 tunnels cannot be established between spoke-to-spoke in DMVPN. Which two commands are missing? (Choose two.)

A. The ip nhrp redirect command is missing on the spoke routers.

B. The ip nhrp shortcut command is missing on the spoke routers.

C. The ip nhrp redirect command is missing on the hub router.

D. The ip nhrp shortcut command is missing on the hub router.

E. The ip nhrp map command is missing on the hub router.

Browse 901 Q&As
Questions 5

Refer to the exhibit.

An engineer receives this error message when trying to access another router m-band from the serial interface connected to the console of R1. Which configuration is needed on R1 to resolve this issue?

A. Option A

B. Option B

C. Option C

D. Option D

Browse 901 Q&As
Questions 6

Refer to the exhibit.

A client is concerned that passwords are visible when running this show archive log config all. Which router configuration is needed to resolve this issue?

A. MASS-RTR(config-archive-log-cfg)#password encryption aes

B. MASS-RTR(config)#aaa authentication arap

C. MASS-RTR(config)#service password-encryption

D. MASS-RTR(config-archive-log-cfg)#hidekeys

Browse 901 Q&As
Questions 7

A company is looking to implement VPN between their Head Quarter and over 100+ Branch Offices. They are looking for a solution that:

1.

Reduces deployment complexity

2.

Simplifies branch communications

3.

Offers branch to branch connectivity.

4.

Is cost effective

5.

Offers strong encryption

Select the best option from the below options that you would recommend to implement.

A. MPLS

B. IPSEC

C. DMVPN

D. GRE

Browse 901 Q&As
Questions 8

Refer to the exhibit.

R1 uses SP1 as the primary path. A network engineer must force all SSH traffic generated from R1 toward SP2. Which configuration accomplishes the task?

A. Option A

B. Option B

C. Option C

D. Option D

Browse 901 Q&As
Questions 9

What does the MP-BGP OPEN message contain?

A. MPLS labels and the IP address of the router that receives the message

B. the version number and the AS number to which the router belongs

C. IP routing information and the AS number to which the router belongs

D. NLRI, path attributes, and IP addresses of the sending and receiving routers

Browse 901 Q&As
Questions 10

What is an MPLS LDP targeted session?

A. session between neighbors that are connected no more than one hop away

B. LDP session established between LSRs by exchanging TCP hello packets

C. label distribution session between non-directly connected neighbors

D. LDP session established by exchanging multicast hello packets

Browse 901 Q&As
Questions 11

An engineer is creating a policy that overrides normal routing behavior.if the route to a destination of 10.100.100.0/24 is withdrawn from the routing

Table, the policy must direct traffic to a next hop of 10.1 1.1. if the route is present in the routing table, then normal forwarding must occur.

Which configuration meets the requirements?

A. access-list 100 permit ip any any ! route-map POLICY permit 10 match ip address 100 set ip next-hop recursive 10.1.1.1

B. access-list 100 permit ip any 10.100.100.0 0.0.0.255 ! Route-map POLICY permit 10 match ip address 100 set ip default next-hop 10.1.1.1

C. access-list 100 permit ip any 10.100.100.0 0.0.0.255 ! route-map POLICY permit 10 match ip address 100 set ip next-hop 10.1.1.1 ! route map POLICY permit 20

D. access-list 100 permit ip any 10.100.100.0 0.0.0.255 ! route map POLICY permit 10 match ip address 100 Set ip next-hop recursive 10.1.1.1 ! route-map POLICY permit 20

Browse 901 Q&As
Questions 12

You asked your assistant to implement port address translation on the edge router of your network, which uses the S0 interface to connect to the ISP. When she is finished, you review the configuration by executing the show run command and receive the following results related to the configuration: Which of the following statements are true of the configuration?

A. the wrong interfaces are configured as inside and outside

B. the command establishing the pool of public IP addresses is incorrect

C. the ip nat inside source list command references a non-existent access list

D. the ip nat inside source list command references a non-existent NAT pool

Browse 901 Q&As
Questions 13

The following access lists are applied to an interface connecting two OSPF routers:

What is the result?

A. the DR on the link will begin updating

B. the OSPF adjacency will go down

C. the last deny statement will fail to log traffic

D. the list will only permit IPv6 neighbor advertisements

Browse 901 Q&As
Exam Code: 300-410
Exam Name: Implementing Cisco Enterprise Advanced Routing and Services (ENARSI) (Include 2023 Newest Simulation Labs)
Last Update: May 08, 2024
Questions: 901 Q&As

PDF

$49.99

VCE

$59.99

PDF + VCE

$67.99