Refer to the exhibit.
Sw1 and Sw2 are two Cisco Nexus 9000 Series Switches that run Cisco NX-OS. They are VTEPs in the same vPC domain. Which statement describes what happens in this scenario?
A. Sw1 drops all traffic because there is no (S, G) OIF list to encapsulate VXLAN multicast packets and send them out to the underlay network through the uplink interfaces.
B. Sw1 performs the VxLAN multicast encapsulation and decapsulation for all traffic associated with the VxLAN VNIs.
C. Sw1 and switch 2 perform the VxLAN multicast encapsulation and decapsulation for all traffic associated with the VxLAN VNIs, depending on the hashing.
D. Sw2 did not send an IP PIM register to the rendezvous point for the multicast group of the VXLAN VNI.
Refer to the exhibit.
The EEM script fails to send an SNMP trap when a user attempts to enter configuration mode. Which configuration is missing from the script?
A. event statement
B. event-default action statement
C. policy-default action statement
D. IP address of the SNMP server
Refer to the exhibit.
The spanning tree is blocking the connection between N9K-DC1-Core-1 and N9K-DC1-Access-1. All ports are up and configured. Which configuration resolves the issue?
A. Set the pathcost method to long on all three switches
B. Configure a vPC between N9K-DC1-Core-1 and N9K-DC1-Access-1
C. Configure LACP between N9K-DC1-Core-1 and N9K-DC1-Access-1
D. Lower the spanning tree cost on the connection between N9K-DC1-Core-2 and N9K-DC1-Access-1
An engineer enables the packet postcards feature on a Cisco Nexus 9000 Series Switch but receives the error message
"Error: Cannot configure postcard when inband-telemetry is configured."
Which action resolves the issue?
A. Disable the telemetry feature
B. Disable the software-telemetry feature
C. Disable the hardware-telemetry feature
D. Disable the inband-telemetry feature
Refer to the exhibit.
VSAN traffic is not routed as expected. Which action should be taken to resolve the issue?
A. Reset the error packet counter
B. Configure the hello timer to match the neighbor
C. Configure the FSPF dead interval with a value higher than 80 seconds
D. Reset the inactivity timer on switch-2
Refer to the exhibit.
An engineer is troubleshooting the connectivity between Server-1 and Server-2. Which action resolves the connectivity issue?
A. Enable BGP advertise pip feature on both leaf switches
B. Configure the same source IP address on NVE and virtual peer link on leaf switches
C. Classify CFS messages for strict priority queue on spine switches
D. Change all ports on spine switches as port-type fabric
Refer to the exhibit.
An engineer fails to implement a Cisco UCS Manager integration manager. The credentials and IP connectivity between Cisco APIC and UCS Manager are configured as expected. Which action resolves the issue?
A. Disable HTTP to HTTPS redirection in Cisco UCS Manager
B. Enable JSON API on the Cisco UCS Manager
C. Change the Integration Manager name to FQDN of the Cisco UCS Manager
D. Install ExternalSwitch app in the APIC controller
A network engineer troubleshoots an issue at a Cisco data center environment with these conditions:
1.
The data center has Cisco Nexus 9000 Series Switches running the vPC setup.
2.
The gateway of the servers is an HSRP IP address between the VLAN interfaces configured on both Cisco Nexus switches.
3.
Some of the client application servers are implementing fast-path forwarding for the return traffic.
4.
Those servers are sending the return traffic to the VLAN interface MAC address instead of the HSRP MAC address.
The network engineer discovers that some traffic is dropped because it passes the vPC peer link to be forwarded out the vPC interface. What must be configured on the vPC switches to resolve the issue?
A. peer-switch
B. peer-gateway
C. arp synchronize
D. spanning-tree
Refer to the exhibit.
A network engineer is implementing a Cisco UCS environment. The environment consists of eight servers configured with the same service profile template and Windows 2012 installed. The VFC interfaces of five of these servers are showing the error shown in the exhibit. Which action resolves the issue?
A. Modify the vHBAs name in the storage connectivity policy
B. Configure upstream zoning
C. Decommission and recommission the servers
D. Modify the boot order in the boot policy
An engineer configures role-based access control for the Cisco UCS Manager. UserA must be allowed read-only access to the system. These events occur after the system is implemented:
1.
UserA attempts to log in but receives an "Authentication Failed" message.
2.
UserB successfully logs in by using an administrator role.
3.
Both users use valid LDAP passwords.
Which action resolves the issue?
A. Enable primary group rules for LDAP providers
B. Assign a default role policy for remote users
C. Add locales to the LDAP group map of UserB
D. Set the default authentication realm to LDAP
