A customer needs to set up SIP integration on Communication Manager Messaging Application 6.0
What are three pieces of information that are needed to meet this requirement? (Choose three)
A. Signaling group number
B. SIP domain
C. Transport Method
D. Extension length
E. Hunt Group number
Which gateway command resets the Gateway back to factory default?
A. Reset
B. Restart
C. Softboot
D. Nvram init
A technician wants to test and see if the voice channel between two IP phones Which command in site administration terminal (SAT) can be used to determine?
A. Status station
B. Status shuffling
C. List station
D. Test station
In the navigation pane, what are the steps to create a test mailbox on the Communication manager messaging 6.0 Application?
A. Select messaging administration, then Subscribe Management, and then click Add or edit.
B. Select messaging administration, the click new.
C. Select messaging administration, Select messaging administration, and then click add.
D. Select Forms control, and then at the command line run then add subscribe command.
When configuring a G450 Media gateway, which two port settings must be set? (Choose two)
A. FTP Server
B. 100 MB port speed
C. Auto-negotiation enabled
D. Full Duplex
Which Ethernet port on S8800 server is connected to the customer network?
A. ETH0
B. ETH1
C. ETH2
D. ETH3
A newly installed main Cm 6.0 server indicates it is in license error mode. A technician again 45 minutes later and it is still in error mode. The license was installed from the system management interface (SMI)?
Which statement describes the reason for the error mode?
A. The installer used the wrong interface to install the license and it is therefore not installed.
B. The server cannot communicate with the IPSI or media gateway whose serial number was used in the license file.
C. The license audit runs every 60 minutes and the error will be resolved in 15 minutes.
D. The installer loaded a license for one of the survivable servers, not the main server, and the IPSIs, media Gateways, and/or IP phones have registered to it
Which statement describes the action to assure the CM_Simplex Template was installed correctly?
A. From browser logged into Systen Management Console, verify cm and utility_Server appear and application state is running.
B. From a browser using the communication Manager IP address, successfullylog into the communication manager system management interface (SMI)
C. When monitoring the template installation workflow status, verify the message, "Wizard completely successfully" displays.
D. From a browser logged into communication manager, select administration > server( maintenance)> server>process status, click on view and verify communicaMgr appears.
A customer has a communication Manager R6.0 system with IP phones and some older TDM phone, and says there is no dial tone for all of the IP phones. All of the hardware has been verified to be working properly.
Which two steps can be taken to identify the cause of problem? (Choose two)]
A. Verify that the TN2602 Media resources circuit pack has the correct IP settings.
B. Verify that the processor Ethernet mode is enabled in the Server.
C. Set a static IP address on a laptop and see if the server can be pined
D. Set a static IP address on a laptop and see if the TN2602 Media Resource circuit pack can be pinged.
Which two hardware components support CM_survRemote template? (Choose two)
A. S8730 Servers with 8 GB RAM
B. S8800 Servers
C. S8510 Server with 8 GB RAM
D. S8300D Server
