An engineer is configuring the VSP 9000 for EDM management, and cannot connect from the EDM computer to the VSP 9000.
Once logged into the ACLI, which show command is used to see the status of the web server?
A. show vsp edm server
B. show ip web-server
C. show sys webserver
D. show web-server
For maximum cooling, how many cooling modules does a Virtual Services Platform (VSP) 9000 chassis need?
A. 2 inserted from the front
B. 2 inserted from the back
C. 2 inserted from the front and 4 from the back
D. 2 inserted from the front and 2 from the back
A technician is implementing a new network that contains eight Ethernet Routing Switch (ERS) 8000 switches, and also uses advanced features. One of the eight switches will run Shortest Path Bridging.
Which two licenses are needed in this situation? (Choose two.)
A. one advanced feature license for seven ERS 8000 chassis
B. one Premier license using for the one needing SPB support
C. one advanced feature license for the network
D. one premier feature license for the network
E. one site license per ERS 8600
A port on the Virtual Services Platform (VSP) 9000 is down because of a link_flap condition as shown in the following output:
VSP-9012:1#show interfaces gigabitEthernet state 10/8 ================================================================ Port State ================================================================ PORT NUM ADMINSTATUS PORTSTATE REASON DATE -------------------------------------------------------------------------------------------------- 10/8 up down LINK-FLAP 10/28/10 00:22:50
What is the most likely cause?
A. The spanning tree protocol has detected a loop and placed the port in a blocked state.
B. There is a physical problem, such as a cable problem.
C. One side of the connection is configured for auto-negotiation and the other side is a fixed speed.
D. The port is receiving a large number of destination unknown broadcast packets.
On an ERS 8000 system that is configured for use with IPv6, which command would show whether or not the VRRP instance is configured correctly on a particular interface?
A. show ipv6 interface all
B. show ipv6 interface
C. show system vrrp interface
D. show ipv6 vrrp address
The attempt to manage an Ethernet Routing Switch (ERS) 8000 using a VRRP address was unsuccessful. What is causing this problem?
A. The virtual router identifier is 0.
B. The datacenter interface is set as a critical IP interface.
C. A real IP address is required for management access not a VRRP address.
D. The incorrect MAC offset is configured for the VRRP address.
Refer to the exhibit.
While troubleshooting your VSP 9000 system, you run the command flight-recorder all
1. The associated files ace created.
Based on the information in the exhibit, where are the associated files stored?
A. Internal flash
B. TFTP Server
C. External flash
D. USB Flash device
Which two management ports are available on the VSP 9000 CP module? (Choose two.)
A. Serial interface
B. USB (host) interface
C. Ethernet interface
D. Modem interface
Which CLI command is used to allow the non-secure (HTTP) web interface?
A. web-server enable
B. web secure disable
C. no web secure-only
D. config web secure enable
Which statement about the local router MAC addresses on RSMLT aggregation switches (cluster) is true?
A. On a RSMLT aggregation switch pair, local router MAC addresses are exchanged, and only used in case of switch failure.
B. On a RSMLT aggregation switch pair, local router MAC addresses are exchanged, and always used for data forwarding.
C. On a RSMLT aggregation switch pair, the virtual MAC address is exchanged, and used for data forwarding.
D. RSMLT aggregation switches are not exchanging local router MAC addresses, but are using the IP destination address to forward traffic.
