A technician is installing an Avaya CallPilot with the NTRH40CA MBP96 CAT5 board and two NTRB18DA Mgate cards. When cabling the NTRB18DA Mgate cards in a Communication Server 1000S Media Gateway, which statement describes the cabling configuration that is the most valid?
A. Attach the customersupplied RJ-45cables to thefaceof the Mgate cards and then to the MBP96 card.
B. Attach the customer supplied RJ-45 cables to the backplane of the Media Gateway or MediaGateway expansion cabinet and then to the MBP96 card.
C. AttachNTDU0609 cables to the face of the Mgate cards and route them outside the Media Gateway. Then couple the customer supplied RJ-45 cables from the NTDU0609 to the MPB96 cards.
D. Attach the NTDU0609 cables to the face of the Mgate cards and take them outside the Media ay lo a customer supplied Ethernet hub. Attach RJ-45 cable from the hub to the MPB96cards.
Working as a team, the Project Manager has just finished programming the agents in the PBX, while technician configured them in Avaya CallPilot. When Avaya CallPilot hoots into service, all channels come up except for one. Prior to the replacement of hardware, it is decided to look into the Event log. Which event below gives a possible clue us to what the problem is?
A. DialogicEventManagement system initialization failed.
B. IMAreceived a disk full event.
C. Event from Blue Call Router: All Port Busy Indication.
D. TN/DN mismatch.
A customer makes a call from their mobile telephone to Ext A on a PBX. Ext A is call-forwarded to Ext B. There is nobody to answer the call at Ext B, so the call is transferred to the Avaya CallPilot voicemail system. How will Avaya CallPilot treat the message?
A. the message will be storedin the mailbox for Ext A
B. the message will be storedin the mailbox forExtB
C. themessage will be stored in thegeneraldelivery mailbox
D. the message will be transferredto the operator
The customer has installed Application Builder on a client PC, but is unable to establish a connection the Avaya CallPilot server. Which two are possible causes of the problem? (Choose two.)
A. SSL is not configured correctly.
B. FTPis not supported on the platform.
C. There is not 20-30 Mbytes of free space on the PC.
D. The IP address and Host Name are not defined correctly.
At a customer site with a Communication Server (CS) 1000 system, a technician is configuring the CS1000 to support the installation of an Avaya CallPilot RIs. 5.0 system. When defining the Avaya CallPilot service in the customer data block in overlay 15, which two options must be enabled?
A. Call Park Allowed (CPA) and Message Register (MGCR)
B. Call Park Allowed (CPA) and Message Center Included (MCI)
C. Maximum number of agents (MAXP) and Message Register (MGCR)
D. Number ofcall registers (NCR) and Message Center Included (MCI)
A customer site has a Communication Server (CS) 1000 system and a newly installed Avaya CallPilot RIs. 5.0 on a 600r server. A technician is tasked with installing the Avaya CallPilot Reporter application. Avaya CallPilot Reporter is installed as an option when which Avaya CallPilot web application is installed?
A. My CallPilot
B. Avaya CallPilot Manager
C. Avaya CallPilot Application Builder
D. Avaya CallPilot UnifiedMessaging
A technician is preparing to set up and install an Avaya CallPilot Rls. 5.0 system. With respect to power considerations, which two rules apply? (Choose two.)
A. The power can originate from any service panel.
B. All power for the Avaya CallPilot must originate from the same service panel.
C. The electrical service panel must not be used for lights or motors.
D. The electrical service panel can be used for any electrical device.
At a customer site with a Communication Server (CS) 1000 system and an existing 201i server running Avaya CallPilot RIs. 2.02. A technician is preparing to upgrade the server to RIs. 5.0. What is the minimum hard disk drive requirement to support the upgrade on this server?
A. One 20 GD hard drive
B. One 70 GB hard drive
C. Two 20 GB hard drives
D. Two 36 GB hard drives
An Avaya CallPilot system administrator is preparing to install Application Builder. Which two places is the Application Builder installation software located? (Choose two.)
A. on the Avaya CallPilot Server
B. on the Avaya CallPilot image DVD
C. on the Avaya CallPilot Applications CD
D. in theEnterprise Solutions PEP Library (ESPL)
The Avaya CallPitol server being set up needs to be configured for the customer's network. These settings are accessed using the Avaya CallPilot Manager Home Page. Which feature is used for these settings?
A. Avaya CallPilot Manager
B. Configuration Wizard
C. Local Site Information
D. HyperTerminal console
