Where in the controller would we configure a wireless network NOT to use encryption?
A. AAA profile
B. SSID profile
C. ARM profile
D. Radio profile
E. VAP profile
The characteristics of 802.1X Authentication include (Select three):
A. L3 Authentication
B. Extensible Authentication Protocol
C. Support of RADIUS external authentication
D. Port based authentication
E. EAP terminates on authenticator
FQLN can be set for an AP: (Select two)
A. At the factory
B. During AP provisioning
C. Using the FQLN mapper tool
D. By DHCP when an address is requested
E. Using the AP wizard
In decrypt-tunneled forwarding mode, which of the following is true?
A. Client sets up an IPSEC tunnel with the controller
B. The AP decrypts and then the 802.11 frame is sent in a GRE tunnel to the controller
C. The AP decrypts the 802.11 frame and bridges it on the wire
D. The AP decrypts the 802.11 frame, encrypts it as an Ethernet frame and sends it to the Controller
E. Clients decrypted traffic is sent down the GRE tunnel
When configuring a default gateway in the startup wizard it must be a part of:
A. A VLAN configured with an IP interface and assigned to a port
B. An IP range that is not assigned to a port or VLAN
C. A VLAN assigned to a port but without an IP interface configured
D. A VLAN not configured on the controller
E. The management Vlan
Which of the following information is gathered by APs during scanning periods? (Select three)
A. MAC addresses of neighboring APs
B. Security threats in the surroundings
C. Type of non-802.11 interference detected
D. Interfering Clients connected to other APs
E. 4.9 GHz devices
The AP Wizard allows the selection of APs to be provisioned using which of the following methods (Select three):
A. APs in particular AP Group
B. All APs
C. APs designated as Air Monitors
D. APs meeting specified search criteria
E. APs of a specific type
Which role is assigned prior to launching the captive portal splash screen?
A. Pre-authentication role
B. Post-authentication role
C. AAA role
D. AAA-CP role
E. CP default role
Which roles must be configured via the startup wizard when captive portal is being configured (Select Two)
A. Roles are not used on the Aruba system
B. Pre-Authentication role
C. Authenticated role
D. Unauthenticated role
E. The Logon Role
When configuring the Mobility Controller's internal DHCP via the startup wizard which option is NOT available for configuration (select two)?
A. Pod name
B. Default router
C. Option 43
D. Domain name
E. Netbios name server
