What is a characteristic of disk-drive Spin Down?
A. Spin Down is only available on CX4.
B. Drives 0-4 are eligible for Spin Down.
C. Drive Spin Down is available for thin LUNs.
D. Drive Spin Down is available for all drives.
Which statement accurately describes DAE3P enclosures?
A. Supported on CX3 and CX4 series arrays
B. Support the 2 Gb/s LCC card
C. Contain 14 disk drives
D. Support FC, ATA, Flash drives, and SATA-II drives
How many front-end ports are required to provide failover between SPs for eight direct-attached hosts on a CX4?
A. 16
B. 8
C. 4
D. 2
Refer to the exhibit.
Which port is configured during array initialization?
A. A
B. B
C. C
D. D
E. E
Refer to the exhibit.
By default how many hosts will see HLU0?
A. 5
B. 4
C. 1
D. 2
A customer's Windows 2008 server has four NICs connected to the private subnet used for iSCSI traffic. Server IP parameters are left at the default settings. How will iSCSI I/O traffic be distributed across the NICs?
A. One NIC will carry iSCSI traffic and the rest will be in standby.
B. The four NICs will carry iSCSI traffic in a round-robin pattern.
C. The four NICs will be divided into two active/passive pairs.
D. iSCSI traffic will be balanced across all four NICs.
A customer is unable to connect to a CX4 after assigning an IP address to their iSCSI HBA. What needs to be configured in order to make a connection?
A. Initiator network parameters
B. iSCSI security
C. iSCSI.conf file
D. Initiator registration
An existing CLARiiON array running release 26 FLARE code is being converted to a CX4 and release 30 FLARE code. You discover clone LUNs are in use on the existing array. What must be done before the conversion?
A. Change the CPL size from 128 MB to 1GB.
B. Change the CPL size from 128 MB to 256 MB.
C. Change the CPL size from 256 MB to 128 MB.
D. Change the CPL size from 128 MB to 512 MB.
Refer to the exhibit.
Which slots contain CR8 core blades?
A. 5 and 8
B. 1 and 2
C. 4 and 10
D. 6 and 7
During the discovery phase of the Array Initialization Utility, what do you use to identify the array you want to configure?
A. Serial number
B. MAC address
C. World Wide Name
D. Controller/target/LUN
