A customer is implementing an EMC VMAX array and wants to manage it using the new management console for the Symmetrix VMAX.
Which entitlement must the VMAX system have to achieve this?
A. SYMM_VMAX_SMC eLicense.
B. SYMM_VMAX_SRM eLicense.
C. SYMM_VMAX_DCP eLicense.
D. SYMM_VMAX_SPC eLicense.
Which Unisphere for VMAX view shows all the components of a masking view including the members of the various groups (port, storage and initiator)?
A. Masking Views --> Connections
B. Masking Views --> Details
C. System Dashboard
D. Storage Groups --> Details
What are the five possible states of the FAST controller?
A. Enabled, Disabled, Disabling, DisabledwithError, Degraded
B. Enabled, Enabling, Disabled, DisabledwithError, Degraded
C. Enabled, Disabled, Disabling, DisabledwithError, Error
D. Enabled, Disabled, Disabling, DegradedwithError, Degraded
Which component of the Symmetrix VMAX runs the scripts to change the configuration of an array?
A. Symmetrix Service Processor
B. Global memory
C. Back end adapters
D. Front end adapters
What are the characteristics of the port groups on Symmetrix storage arrays running Enginuity 5876?
A. May contain valid front-end ports, only fibre and GigE ports, enabled ACLX flag on ports.
B. A port belongs only to one port group, enabled ACLX flag on ports, only fibre and GigE ports.
C. Can have mixed port types, only fibre and GigE ports, disabled ACLX flag on ports.
D. Enabled ACLX flag on ports, can have mixed port types, can contain valid back-end ports.
Which Open Replicator transfer mode allows for more than one concurrent copy?
A. Cold Push
B. Cold Pull
C. Hot Push
D. Hot Pull
What Unisphere for VMAX section is used to monitor and terminate VLUN migration sessions?
A. Data Protection
B. Storage
C. System
D. Performance
In a single-hop SRDF/AR setup, the options have been set as follows:
-Cycle Time = 3000
-Delay Time = 2000
-
Overflow = Next
The symreplicate session was started at time 0. The actual cycle time was 4500 seconds.
How many seconds after the start of the first cycle will the next cycle start?
A.
4500
B.
6000
C.
6500
D.
9000
What is the state of the SRDF pair immediately after executing an "Establish" command?
A. SyncInProg
B. Establishing
C. Updating
D. Copying
Refer to the exhibit.
The SAN zones (Zones 3 and 4) shown in the exhibit have been created during an Open Replicator implementation. The control devices in the Symmetrix array are mapped to both front- end ports. Which Open Replicator operations can be performed?
A. Hot Push and Pull, Cold Push and Pull
B. Cold Push and Cold Pull only
C. Hot Push and Hot Pull only
D. Hot Pull and Cold Pull only