For the creation of the central starting point there are several techniques. In the given situation it is necessary that consistency between the data entered is guaranteed. Which of the techniques below is preferable if only one technique may be used?
A. use of production data
B. entering through separate front-end software
C. entering through regular system functions
See the decision and test situations below: R = (A AND B) OR C
Which test situation is missing if the coverage type decision points modified condition/decision coverage is used?
A. Option A
B. Option B
The specification of test cases according to a test design technique follows five general steps. Which step is stablishing the starting point?Which step is ?stablishing the starting point?
A. step 2
B. step 3
C. step 4
D. step 5
See the illustration below:
What is the minimum number of logical test cases generated by the use of the Process Cycle Test if the coverage type paths test depth level 2 is used?
A. 3
B. 5
C. 6
D. 9
Three parameters play a role for a printing function and for every parameter there are two equivalence classes to be tested:
Which combination is missing in the table if the coverage type pairwise testing is applied?
A. arial color 10
B. arial black 12
C. verdana color 10
D. verdana black 10
What constitutes a good test environment?
A. it is possible to adequately determine to what extent the test object meets the requirements
B. it has been configured and tested by qualified personnel
C. it meets both of the requirements listed above
D. it is as similar to the production environment as possible and the test data is consistent
See the figure below:
Of which test design technique is this an example?
A. Data Combination Test
B. Data Cycle Test
C. Semantic Test
D. Syntactic Test
What is not an element of a test case in relation to the system behavior to be tested?
A. action
B. defect
C. initial situation
D. predicted result
Drivers can be used in the Execution phase of a test process. What are drivers for?
A. to test, at an early stage, a module that has relationships with modules not yet realized
B. to gain insight into aspects like memory use, CPU use, network load and performance
C. to determine whether the system continues to function correctly and at the required speeds under the expected production load
Is the checklist created to determine the test basis dependent on the selected test design technique?
A. yes
B. no