Click on an Onboard Administrator module in the graphic.
Hot Area:
Hot Area:
Which tool can be used to deploy firmware and software updates to a ProLiant blade?
A. HP Smart Update Manager
B. HP System Management Homepage
C. Service Pack for Proliant
D. Insight Diagnostics
You have a c7000 enclosure with 1 GB Pass-Thru modules. You cannot get to the network from any of the blades. What should you verify first for proper connectivity to the network?
A. external switch set to half duplex
B. interconnect link between the Pass-Thru modules
C. external switch supports Gigabit speed
D. correct SFPs are installed
What should you use to check the overall health status of all the BL460c Gen8 servers you recently installed in a c7000 enclosure?
A. Power Manager
B. Array Configuration Utility
C. Onboard Administrator
D. Insight Control Server Deployment
While troubleshooting a problem, you need to get a report from a ProLiant BL460c Gen8 Server detailing the firmware and driver revisions. Which report should you obtain?
A. Active Health Logs
B. Array Diagnostics Report
C. ILO Event Logs
D. Integrated Management Log
Which information can you find on Insight Display?
A. server memory errors
B. server mezzanine errors
C. server hard drive errors
D. server Smart Array
After a firmware upgrade is completed, you cannot access the Onboard Administrator (OA) web interface. What should you do first to address this issue?
A. Set the IP address of OA module.
B. Upload the configuration file.
C. Set the maintenance switch to Off.
D. Clear the web browser cache.
Which command can be used to display the currently installed EFi on a BL870c Server Blade?
A. romdrivers
B. ver
C. info
D. bcfg
Which feature of the Ultrium 448 Tape Blade allows quick recovery of the operating system?
A. ACU
B. ORCA
C. OBDR
D. RBSU
A customer has a ProLiant BL680c G5 Server Blade with an Integrated HP Smart Array P400i Controller with 256MB ECC protected cache. An application runs slowly whenever there are large bursts of disk writes. How can this be prevented?
A. by adding more internal disks to distribute the load
B. by creating a larger swap file to handle the extra load
C. by changing the internal disks from RAID 1 to RAID 5
D. by installing an optional 512MB cache with BBWC
