A customer is planning to deploy HP MSM466-R access points in an extreme cold environment to interconnect to the Unified Wired-WLAN Module in the HP switch. Which requirement is needed to accomplish this?
A. NEMA 4X enclosures should be used to house the access points.
B. Switch ports must support PoE.
C. PoE redundancy must be enabled on the interface.
D. Access Point must deploy internal antennas.
A research company wants to deploy a high throughput 802.11n only wireless network. The network administrator selects the "client dot11n-only" option. Which other configuration option must the network administrator configure?
A. maximum MCS index
B. basic rate 6Mb/s
C. mandatory rates MCS0-MCS15
D. MCS15 data rate
HP has released a new version of an access controller software package file. How does the network administrator activate the new software version?
A. by interrupting the boot sequence and selecting the Update Bootware option
B. by interrupting the boot sequence and selecting the Boot Extend Bootware option
C. by interrupting the boot sequence and selecting the Boot Backup Bootware option
D. by interrupting the boot sequence and selecting the Update Full Bootware option
Which factors impact the calculation of the Effective Isotropic Radiated Power (EIRP)?
A. antenna gain, cable loss, and transmit power
B. propagation loss, receiver sensitivity, and transmit power
C. antenna height, interference, and receiver signal strength
D. antenna gain, propagation loss, and transmit power
Which customer requirements would cause a WLAN designer to recommend implementing an HP Unified Wired-Wireless enterprise controller? (Select two.)
A. The customer currently has 500 access points and an HP MSM controller deployed, and they plan to deploy an additional 400 access points.
B. The customer expects that the number of authenticated users will increase from 1500 to 2500.
C. The customer wants to manage their wireless network using the HP IMC platform.
D. The customer requires high availability and seamless failover of non-centralized traffic,
E. The customer plans to deploy a new wireless network with 500 access points.
A corporate user accesses a corporate network on SSID CORPORATE. The user endpoint is set up for 802.1X in PEAP-MSCHAPV2. HP BYOD is implemented.
Wireless is set up on a HP Unified Wireless controller
Accounts have been synchronized with an Active Directory Domain controller.
In this scenario, access to SSID CORPORATE fails, and the User Access Log > Auth. Failure Log in User Access Manager (UAM) does not show any events. Which components should the network administrator check to determine the cause of this?
A. setup of RADIUS scheme on the Wireless controller and setup of Access Device in UAM
B. DHCP relay on L3 switch and DHCP agent
C. Certificate Installation in UAM and SSID in wireless controller
D. BYOD Portal and HTTP agent
Refer to the exhibit.
A company wants to connect a mid-size branch office to their corporate location. An HP 10500/7500 Unified Wired-Wireless module is deployed at the corporate location. A maximum of six HP MSM access points will be deployed at the branch location.
Which HP device meets these customer requirements and is the most cost effective solution for the branch location?
A. HP 830
B. HP 870
C. HP 2920
D. HP 7500
Which feature must be enabled globally on the VLAN of the wireless interface to enable multicast optimization?
A. Internet Group Management Protocol
B. Inter Access Controller Tunneling Protocol
C. Simple Network Management Protocol
D. Lightweight Access Point Protocol
A network administrator wants to set a DNS proxy that forwards DNS traffic to a DNS Server on 10.1.1.1.
Which HP Comware command set, executed in system-view mode, is required to set this?
A. dns resolve dns proxy dns server 10.1.1.1
B. dns resolve dns proxy enable dns server 10.1.1.1
C. dns proxy resolve dns server 10.1.1.1
D. dns proxy enable dns server 10.1.1.1
A corporate user accesses a corporate network on SSID CORPORATE. The user endpoint is set up for 802.1X in PEAP-MSCHAPV2: HP BYOD is implemented.
Wireless is set up on an HP Unified Wired-Wireless Controller
Accounts have been synchronized with an Active Directory Domain controller.
A. Setup of RADIUS on the Wireless controller and User Access Manager. Certificate server installation. BYOD Portal setup
B. Setup of 802.1X Authentication on the wireless controller Installation of certificates in User Access Manager (UAM) Setup of RADIUS on the wireless controller and UAM
C. Setup of 802 1X Authentication on the wireless controller Setup of RADIUS on the wireless controller and User Access Manager Fingerprinting with the DHCP agent
D. Setup of 802 IX Authentication on the wireless controller Setup RADIUS on the wireless controller and User Access Manager Fingerprinting with the HTTP agent
