Control limits would be found in which of the following plans?
A. Procurement management plan
B. Quality management plan
C. Change management plan
D. Scope management plan
Post-mortem analysis occurs in which of the following process groups?
A. Closing
B. Pre-project setup
C. Monitoring / controlling
D. Planning
A project manager has to complete an asset inventory project for a large corporation. Several departments have refused to allow access to the equipment to complete the project. The project manager should update which of the following?
A. Change control form
B. Risk register
C. Work Breakdown Structure (WBS)
D. Issues log
Which of the following is the BEST reason to conduct a feasibility analysis?
A. To ensure that risks are addressed during the project
B. To authorize a project
C. To gather technical data
D. To assign team member roles
Which of the following will have the GREATEST impact upon the outcome of a project? (Select Two).
A. Quality metrics
B. Scope creep
C. Performance reports
D. Project life cycle
E. Project delays
A project manager was asked to complete a project three weeks early and not crash the project. Which of the following should be done?
A. Move some of the task to another release.
B. Have the team work over time and give them time off later to save the budget.
C. Continue to work and complete the project as soon as possible.
D. Review the plan with the team and develop a way to reduce the time
Which of the following would be the impact upon a project if the CPI for the project is .75?
A. The project is under-budget.
B. There would be a 25 percent cost decrease.
C. There would be a 75 percent cost increase.
D. The project is over-budget.
A project manager has just completed the planning of a project, but cannot start the project execution until granted permission from the project sponsor. This is an example of which of the following actions?
A. Stakeholder analysis
B. Risk assessment
C. Audit review
D. Phase gate
An ongoing project requires several parts manufactured at an outside vendor. If the vendor has sufficient quantity and can still ship today, the parts should be received in five days; although in most cases an order of this size requires ten days. Allowing for an upcoming holiday and some potential bad weather the shipment could take up to twenty-one days. Using the PERT method, which of the following is the correct time estimate for a parts delivery?
A. 10 days
B. 11 days
C. 21 days
D. 36 days
A project manager is concerned that certain aspects of a project may not meet the local regulations. Which of the following is the project manager concerned with?
A. Standards compliance
B. Phase gate approval
C. Internal process compliance
D. Company compliance
