Given the following configuration: interfaces { so-0/0/0 { unit 0 { family inet { address 10.10.10.1/24; } } } so-0/0/1 { unit 0 { family inet { address 20.20.20.1/24; } } } lo0 { unit 0 { family inet { address 192.168.1.1/32; } } } Which is considered an exception packet?
A. IP packet addressed to 10.100.100.10
B. ICMPtraceroute packet with TTL set to 5
C. IP packet with the Router Alert option set
D. ICMP echo request addressed to 172.16.1.1
A firewall filter is applied as an input filter on a transit interface. What three types of traffic will this affect? (Chose three.)
A. outbound traffic transiting the router
B. traffic destined to the Routing Engine
C. inbound traffic transiting the router
D. traffic destined to the interface address on which the filter is applied
When a router receives a label of zero it will _____.
A. perform a label swap
B. perform a label pop
C. send an error message toward the ingress router
D. perform a label push
By default, which command can be used to display information about packets that have been logged with the syslog firewall filter action?
A. show log
B. show firewall
C. show log messages
D. show firewall log
When a router receives a label of zero it will _____.
A. perform a label swap
B. perform a label pop
C. send an error message toward the ingress router
D. perform a label push
Which CLI command displays routes advertised to an EBGP peer?
A. showbgp advertised routes x.x.x.x
B. show route advertising-protocolbgp x.x.x.x
C. show route receive-protocolbgp x.x.x.x
D. showbgp received routes x.x.x.x
Which RP election mechanism can load balance among multiple candidate RPs by default?
A. bootstrap router
B. static
C. auto-RP
D. sparse-RP
Which two statements are true concerning the JUNOS software? (Choose two.)
A. Processes run in a protected memory environment.
B. Processes are fully independent from each other.
C. Processes are tightly integrated with each other.
D. Processes may fail and cause a failure of the entire system.
By default, which routing table do multicast-enabled routers use to perform an RPF check?
A. inet.1
B. inet.2
C. inet.0
D. inet.3
From the [edit] level of the configuration hierarchy, which command assigns a router its autonomous system number?
A. set protocolsbgp group ibgp autonomous-system
B. set protocolsbgp autonomous-system
C. set routing-optionsbgp autonomous-system
D. set routing-options autonomous-system
