The snapvault update command is only available on the secondary system.
A. True
B. False
Which one of the following commands is used to specify the destination appliance(s) that are allowed to replicate (pul data from the source appliance?
A. optionssnapmirror.allow
B. snapmirror release
C. snapmirror initialize
D. optionssnapmirror.access
To restore a primary SnapVault qtree to the exact qtree location on the primary storage system (from which it was backed up), you must:
A. Add the newqtree to the primary storage system
B. Restore to a non-existingqtree
C. Overwrite the existingqtree on the primary storage system
D. Delete the existingqtree from the secondary storage system
If the local node has its FC HBA connected to switch Bank 1, it owns the disks connected to switch bank
.
A. 1
B. 3
C. 4
D. 2
Which one of the following actions will cause a currently in sync snapmirror relationship to fall out of sync?
A. Modifying the /etc/snapmirror.conf file on the source storage appliance
B. Modifying the /etc/snapmirror.conf file on the destination storage appliance
C. Runningsnapmirror update on the source storage appliance
D. Runningsnapmirror release on the source storage appliance
Which one of the following /etc/snapmirror.conf entries will not support synchronous SnapMirror?
A. FilerA:source_vol FilerB: destination_vol- sync
B. FilerA: source_vol FilerB: destination_vol outstanding=3s sync
C. FilerA: source_vol FilerB: destination_vol-0-55/5***
D. FilerA: source_vol FilerB: destination_vol visibility_interval=1hr, outstanding=3ms, cksum=crc32 sync
Which one of the following statements apply to Advanced Single Instance Storage (ASIS)?
A. Eliminates duplicates files inSnapVault for NetBackup secondary volumes
B. Eliminates duplicates blocks inSnapVaultfor NetBackup source volumes
C. Eliminates duplicates blocks inSnapVault for NetBackup secondary volumes
D. Eliminates duplicates files inSnapVaultfor NetBackup source volumes Correct answers
While troubleshooting a double disk failure with SyncMirror. You decide to remove and destroy a plex from a mirrored volume. What steps would you perform to remove a plex from a mirrored volume?
A. Ensure the plex is offline and use the vol destroy plexname command.
B. Ensure the plex is online and use the vol destroy plexname command.
C. Take the volume offline and use the vol destroy command.
D. Take the volume offline and use the vol destroy -f command.
Which command disables client access to Snapshot copies on a volume called flexvol1?
A. cifs shares-change flexvol1 -nosnap
B. snap access flexvol1 off
C. vol options flexvol1 nosnapdir on
D. vol options flexvol1 snapdir off
E. vol options flexvol1 snapdir on
For DOT 7.3 and higher, which is true about SnapVault or Open Systems SnapVault and deduplication?
A. Deduplication is not supported with SnapVault/ Open Systems SnapVault.
B. Adeduplication schedule can be enabled for SnapVault secondary systems.
C. Deduplication is recommended for SnapVault primary systems because it replicates data in a deduplicated state
D. When enabled on the secondary system,deduplication runs after each SnapVault / Open Systems SnapVault transfer.
