What are two functions of iSCSI access lists? (Choose two.)
A. control the network interfaces on the storage system that an initiator can access
B. define authentication parameters(CHAP)
C. limit the number of network interfaces advertised by the storage system
D. define MPIO behavior
What is the significance of using a specific LUN type when creating LUNs manually on a NetApp storage system?
A. The LUNs offset, size of the prefix and suffix is determined by the LUN type, which differs for different operating systems.
B. The LUN types are merely for administrative ease of use and the LUN types can be changed on the fly after creation.
C. The LUN types allow the appropriate host operating systems to use the LUN. For example, a VMware type LUN cannot be read from /written to using a Solaris host.
D. The host operating system will panic when the "wrong" LUN type is selected on the NetApp storage system.
When assessing a current storage solution, it is critical to document the current NetApp storage system configuration.
Which factor should NOT be considered when documenting this existing configuration?
A. Data ONTAP version
B. current data layout (RAID groups, aggregates, volumes, etc...)
C. storage system name and IP
D. host power cables and power usage
Which three tasks should be completed as part of the site preparation for install? (Choose three.)
A. plan zoning configuration
B. verify equipment move path
C. determine aggregate layout
D. verify power drops in the equipment location
E. make contact with data center personnel
Which three does NetApp support for iSCSI with Microsoft Windows solutions? (Choose three.)
A. VLANs
B. Jumbo frames
C. NIC teaming
D. Microsoft MCS
E. NIC trunking
You are creating an acceptance test plan and the subject of performance is raised.
How should you define what the minimum performance should be?
A. You should look up the test results for a similar system in previous performance testing and use those numbers.
B. You should work with the customer to understand their performance expectations and determine the minimum performance they require for the application this system will support.
C. You should use the published maximum performance specifications for this system.
D. You should use the published minimum performance specifications for this system.
After completing the configuration of a new Brocade Fibre Channel switch, which command do you use to verify your configuration?
A. switchshow
B. show config
C. configshow
D. cfgshow
Which configuration for primary block (FC and iSCSI) data does NetApp best practices recommend?(Choose two.)
A. single controller single shelf
B. single controller multiple shelves
C. dual controller single shelf
D. dual controller multiple shelves
for access to a VMFS datastore created on a NetApp LUN on an ESX 4.0 system for an ALUA configuration, the path selection policy should be set to:
A. MRU (Most Recently Used)
B. Fixed
C. RR (Round Robin)
D. ALUA
A user wants to access a FCP VMFS datastore created on a NetApp LUN using a properly configured ESX 3.5 system with a new ESX 4.0 system. Without making changes to the LUN or igroup attributes, what setting should be used for the SATP (Storage Array Type Plugin)?
A. VM_SATP_ALUA
B. VMW_SATP_DEFAULT_AA
C. The LUN has to be changed to ALUA before accessing from ESX 4.0)
D. VM_SATP_DEFAULT
