Which of the following statements is true with an Arista switch that has no configuration, but has booted with ZTP disabled?
A. You may login directly as root, but only when using SSH.
B. You may login as root, but only if you login as admin first.
C. You can run root-level commands without a password after logging in as root.
D. You cannot issue root-level commands until you add a user with a password.
ZTP can retrieve either an EOS configuration file or a script at boot. How does the switch determine of the file being retrieved in a script or a configuration file?
A. If the first line of the file ends with a shebang (#!), the file is a configuration file.
B. If the first line of the file starts with a shebang (#!), the file is a script.
C. If the last line of the file ends with a shebang (#!), the file is a script.
D. If the last line of the file starts with a shebang (#!), the file is a configuration file.
Which of the following Arista switches support LANZ?
A. 7010
B. 7150
C. 7500E D. 7048T
Which of the following statements is false?
A. You can run bash commands from CLI with the bash command.
B. You can run CLI commands from bash with the Cli command.
C. You can run CLI commands from bash with the FastCli command.
D. You can run CLI commands from CLI with the Cli command.
Complete this sentence: In an Arista MLAG configuration, interfaces on both devices participate in a ___.
A. group conversation about the fastest Layer 3 routing protocol convergence scenarios
B. negotiation over BGP router ID priorities
C. distributed port channel, enabling all active paths to carry data traffic while maintaining the integrity of the STP topology
D. disabled Layer 1 fiber optic speed negotiation
What command configuration mode enabled you to connect to an Arista Switch via HTTPS for services such as Tap Aggregation?
A. management web secure
B. management web https enable
C. management web commands
D. management api http-commands
When configuring MLAG, Arista recommends that the trunk group command be used on the VLAN used for MLAG peer communication.
What is the purpose of the trunk group command?
A. It groups all the trunks together so that they can traverse the peer-link properly.
B. It groups the MLAG interfaces together so that they can be reported on both peers.
C. It prevents the configured VLAN from leaking out onto other trunks.
D. It ensures that the configured VLAN will be included on all trunks.
Why is FastCli faster than Cli?
A. FastCli utilizes an always-running agent to process the submitted command and return the output.
B. FastCli is not faster than Cli, though the name might suggest otherwise.
C. FastCli is written in C++ while Cli is written in Perl.
D. FastCli uses special engrams from the M5.
What can you assume about Ethernet1 in this output from a 7150-24 that have been configured with the tap aggregation mode exclusive command?
A. Ethernet1 is broken.
B. Ethernet1 has a QSPF interface.
C. Ethernet1 is an Agile Port.
D. Ethernet1 will not work with Tap Agg.
What is the command to make sure that all installed extensions are loaded when the switch reboots?
A. install extensions permanent
B. boot installed-extensions
C. copy extensions: boot-extensions:
D. copy installed-extensions boot-extensions