DRAG DROP
A datacenter administrator has been tasked to perform firmware updates of the whole chassis and its components based on the latest dell.com catalog.
What is the correct sequence of actions?
Select and Place:
A server sled has a single mezzanine card installed in the correctly supported slot. To which IOM fabric(s) does the sled have access?
A. Fabric A1 and Fabric A2
B. Fabric A1 only
C. Either Fabric A or Fabric B, depending on the configuration set in OME-M
D. Fabric A1 and Fabric B1
What is a characteristic of MX7000 networking in Scalable Fabric Mode?
A. Enabled by default, all switch-specific OS10EE capabilities are available.
B. Layer 2 bridging is disabled be default and interfaces must join a bridge domain (VLAN) before being to forward frames.
C. All switch interfaces are assigned to VLAN 1 by default and are in the same Layer 2 bridge domain.
D. Available on MX9116n FSE and MX7116n FEM but not on the MX5108n.
What is a characteristic of MX7000 networking in Full Switch Mode?
A. Layer 2 bridging is disabled by default and interfaces must join a bridge domain (VLAN) before being able to forward frames.
B. Networking is enabled by default and all switch-specific OS10EE capabilities are available.
C. Networking is available on MX9116n FSE and MX7116n FEM but not on the MX5108n.
D. Switches operate as layer 2 I/O aggregation devices and are managed through OME-M.
An MX7000 administrator has been tasked to create a Scalable Fabric Architecture on a 3 chassis setup using Fabric B. Which IOM configuration is recommended?
A. Chassis 1 - Slot B1: MX9116n; Slot B2: MX9116n Chassis 2 - Slot B1: MX5108n; Slot B2: MX5108n Chassis 3 - Slot B1: MX5108n; Slot B2: MX5108n
B. Chassis 1 - Slot B1: MX7116n; Slot B2: MX7116n Chassis 2 - Slot B1: MX7116n; Slot B2: MX7116n Chassis 3 - Slot B1: MX9116n; Slot B2: MX9116n
C. Chassis 1 - Slot B1: MX9116n; Slot B2: MX7116n Chassis 2 - Slot B1: MX7116n; Slot B2: MX9116n Chassis 3 - Slot B1: MX7116n; Slot B2: MX7116n
D. Chassis 1 - Slot B1: MX9116n; Slot B2: MX5108n Chassis 2 - Slot B1: MX5108n; Slot B2: MX9116n Chassis 3 - Slot B1: MX5108n; Slot B2: MX5108n
Which MX7000 feature allows an administrator to virtualize network WWN and MAC addresses?
A. FlexAddress
B. MX Scalable Architecture
C. Identity Pool
D. Virtual Top of Rack
An administrator is configuring a fully populated MX5016s storage sled to be accessed by four MX740c compute sleds. Each compute sled has an H745P Jumbo PERC installed. The disks in the storage sled are evenly distributed across all compute sleds using a Drive-Assigned storage configuration.
What is the maximum number of disks that each compute sled can detect from the MX5016s?
A. 1
B. 2
C. 4
D. 16
What automatically opens a support case with technical support and collects the PowerEdge MX system state information that is required for troubleshooting an issue, then sends it securely to Dell EMC?
A. OpenManage Essentials
B. SupportAssist Collections
C. OpenManage Enterprise
D. SupportAssist Enterprise
An administrator has installed the iDRAC Service Module in the OS on a compute sled, they are unable to use its features in the iDRAC web GUI. What is the likely cause of this issue?
A. OS to iDRAC pass-through feature is not enabled in the iDRAC
B. iDRAC Express license is installed
C. OS and iDRAC are configured on different networks
D. Installed OS is not supported
What type of connection is used by QuickSync 2?
A. Bluetooth
B. NFC
C. QuickAssist
D. LTE
