Through what does RecoverPoint support heterogeneous storage environments?
A. VPLEX
B. Any array-based splitter
C. APIs
D. VMAX splitter only
A new RecoverPoint system is being installed and the RPAs need to be upgraded to the latest version. How should this be done?
A. Choose the option to upgrade the RPA version from an ISO while installing RecoverPoint using Deployment Manager.
B. Before doing the install ensure all the RPAs IP addresses reach each other. Connect to RPA1 with boxmgmt and do the upgrade.
C. Install the new system with Deployment Manager and then log in as boxmgmt and perform the upgrade on one RPA.
D. Upgrade the RPAs to the latest version first; otherwise Deployment Manager will prevent the installation.
A customer environment includes a two-cluster RecoverPoint/SE instance. They have a new data center 100 km away that they wish to protect with RecoverPoint.
What steps are required to connect a new cluster to their existing RecoverPoint instance?
A. Use Deployment Manager to convert the existing instance to RP/EX. Use Deployment Manager to connect the new cluster to the existing instance. Install RP/EX licenses for their existing arrays.
B. Use Deployment Manager to connect the new cluster to the existing instance.
C. Install RP/SE licenses for their existing arrays. Install RP/SE licenses for the new cluster. Use Deployment Manager to connect the new cluster to the existing instance.
D. Install RP/CL licenses for their existing cluster. Use Deployment Manager to connect the new cluster to the existing instance.
A customer is evaluating the deployment of RecoverPoint with their VMAX array. They want to deploy the RPAs in the virtual appliance form. They ask your opinion about using vRPA versus physical appliances.
What should you advise them?
A. They can only use physical RPAs in the current environment.
B. For performance reasons, they can mix vRPAs and physical RPAs in the same RPA cluster, but only at remote sites.
C. For performance reasons, they cannot mix physical and vRPAs within an RPA cluster.
D. They can mix vRPA and physical RPAs in the same RPA cluster at all sites.
The Getting Started wizard that is displayed the first time a user accesses Unisphere for RecoverPoint assists with performing what action?
A. Adding licenses
B. Adding splitters
C. Configuring RPAs
D. Creating Consistency Groups
Which Image Access Mode should be used when large portions of an image might be changed?
A. Logged Access
B. Virtual Access (without Roll)
C. Snap Access
D. Virtual Access (with Roll)
Which ports from a VPLEX Metro system must be zoned to the RPAs in order to install the VPLEX write splitter?
A. FE and BE ports
B. FE ports only
C. BE ports only
D. FA ports
You are adding a new vRPA to a cluster using the Add New RPAs wizard in Deployment Manager. SAN diagnostics fail and you cannot add the RPA. Pings to the vRPA and VNX iSCSI ports are returned successfully.
What is most likely the cause for this connection problem?
A. CHAP authentication not correct
B. vRPA iSCSI ports MTU set to a number lower than 9000
C. Default gateway setting for RPA iSCSI ports not correct
D. Wrong IP version set on vRPA iSCSI ports
During deployment of a vRPA OVF template a temporary IP address must be set to be used by Deployment Manager in later steps.
Which IP address allocation policy should be selected?
A. Fixed
B. Transient
C. DHCP
D. No manual selection needed. The OVF template deployment automatically selects the correct IP allocation policy.
Which three methods are supported for sending system alerts to EMC?
A. FTPS, SMTP, and ESRS
B. FTP, SMTP, and ESRS
C. SMTPS, FTPS, and ESRS
D. HTTPS, SMTP, and ESRS