Refer to the exhibit.
A storage integrator is examining the configuration of an HPE 3PAR storage system using CLI. Which command can be used to display a list of common provisioning groups starting with substring R5 in the system?
A. showcpg R5*
B. cpg show | grep ^R5
C. cpg | grep R5*
D. cmore showcpg –I R5*
A storage integrator is planning an HPE StoreVirtual VSA installation. Which network-related information may be needed for the implementation?
A. DHCP reservation for virtual IP address of the StoreVirtual cluster
B. jumbo frames need to be enabled for iSCSI traffic
C. flow-control needs to be disabled when using 10Gb NICs
D. virtual IP address for the StoreVirtual cluster
What must be configured before a storage integrator can start creating volumes from the available space on an HPE MSA 1040/2040?
A. disk group
B. snapshot space
C. date and time on MSA storage
D. global spare disk
A customer currently utilizing HPE 3PAR StoreServ 7200 is experiencing performance bottlenecks within their SAN storage.
Which cost-effective upsell or cross-sell HPE storage solution will offer significantly more performance and higher capacity to meet their needs and fit within their current infrastructure?
A. HPE 3PAR StoreServ File Controller v3 System
B. HPE 3PAR StoreServ 8440
C. 8-node HPE 3PAR StoreServ 20000 Storage
D. HPE StoreVirtual 3200 Storage
A customer wants to expand their SAN environment, which is based on B-series FC switches. They have a virtualized environment and two HPE 3PAR StoreServ arrays.
Which tools can be used by the Integrator to check the health of the SAN environment before starting the expansion and after finishing? (Choose two.)
A. HPE SAN Network Advisor
B. HPE Complete AntemetA 3PAR Vision
C. Brocade SAN Health
D. HPE Enterprise Fabric Management Suite
E. HPE Central Management Console
The customer has purchased an HPE StoreOnce VSA and their backup software is HPE Data Protector.
What considerations should be taken for support of Data Protector and Catalyst stores?
A. Catalyst only supports Data Protector 64 bit Media Agent.
B. StoreOnce Catalyst only supports Data Protector 6.x and above.
C. Only Data Protector Cell Manager supports writing to the Catalyst store.
D. The Data Protector 64 bit Media Agent supports only VTL and NAS on the StoreOnce.
Refer to the exhibit.
Which command can be used in the CLI console to set the static IP address and DNS server for an HPE StoreOnce device?
A. net set wizard
B. create network
C. setup network
D. run setup
A storage integrator is handing over an installed HPE 3PAR storage system to a customer. The customer wants the original license key of the system for setlicense command that is used to prevent the system from prompting for confirmation of new license key.
Which of the following command shows original license key?
A. showlicense -raw
B. displaylicense
C. licshow
D. licenseshow
The storage integrator is about to add new HPE 3PAR StoreServ 8200 to a customer's existing SAN infrastructure. What must be taken into account when developing a technical action plan?
A. customer change control procedures
B. action plan audience
C. environmental requirements
D. level of support
A customer has requested the storage integrator to assist in installation of a HPE 3PAR StoreServ 8200.
As a best practice, what should be taken into consideration when deploying 3PAR Virtual Service Processor?
A. Microsoft Hyper-V version of Virtual Service processor needs to be deployed to a CSV volume.
B. Installation of the Virtual Service processor is optional with a single two node HPE 3PAR StoreServ.
C. The Virtual Service processor should be deployed on other volume than a volume from the managed HPE 3PAR StoreServ.
D. Virtual Service processor for VMware vSphere should be installed using VMware Fault Tolerance.
