A VIA client tries to initially connect to corporate office controller through an intermediate firewall. However, the VPN connection fails. The administrator examines the firewall rules and determines that rules for UDP 4500 and UDP 500 are configured.
Which additional protocol must be allowed in the firewall rules to resolve this connection failure?
A. TCP 22
B. TCP 443
C. UDP 8200
D. ESP
An administrator wants to add a new folder in AirWave. Where would the administrator perform this action?
A. in AMP Setup
B. in AP/Devices
C. in Groups
D. in Device Setup
A cluster has two Aruba 7240 Mobility Controllers (MCs) and two Aruba 7220 Mobility Controllers (MCs). How is the cluster leader elected if all controllers have the default priority?
A. The 7240 controller with the highest MAC address is elected.
B. The controller with the highest IP address is elected.
C. The controller with the highest MAC address is elected.
D. The 7240 controller with the lowest IP address is elected.
Refer to the exhibit.
What can an administrator determine from this Aruba device output?
A. A switch is connected to a standalone Mobility Controller.
B. An AP is connected to a Mobility Controller in a cluster.
C. An AP is connected to a standalone Mobility Controller.
D. A switch is connected to a Mobility Controller in a cluster.
An administrator creates a User Rule for role derivation on the Mobility Master (MM). Which client information can an administrator specify to identify that a particular user should be assigned a different role from the initial role?
A. IP address
B. VLAN
C. MAC address
D. Profiling information
An administrator mistakenly configures the wrong VLAN setting on a managed controller's interface. This causes the controller to lose management access to the Mobility Master (MM).
Which mechanism will then attempt to restore the previous working configuration on the managed controller?
A. disaster recovery
B. auto-rollback
C. restore config
D. bulk configuration
An administrator needs to add connectivity between two buildings that are within 15 meters of each other on a company's campus. The administrator decides to implement Aruba's wireless mesh feature between an AP in each building. How should the administrator deploy the two APs to implement the mesh feature?
A. one as a Mesh Portal AP and one as a Remote Mesh Point AP
B. one as a Mesh Portal AP and one as a Mesh Point AP
C. one as a Remote Mesh Portal AP and one as a Remote Mesh Point AP
D. one as a campus AP and one as a Mesh Point AP
An administrator wants to implement a cluster of Aruba Mobility Controllers (MCs). Which guideline should be followed?
A. Implement Virtual Mobility Controllers and Mobility Controllers in the cluster to provide scalability.
B. Verify that all the controllers run the same release of software.
C. Purchase a cluster license to enable clustering
D. Implement High Availability (HA) AP Fast Failover for redundancy.
An administrator deploys an Aruba Mobility Controller 7005 to a branch office. The administrator accidentally disables the console port on the controller. Which controller command should the administrator use to re-enable the console part?
A. mgmt-user console
B. console enable
C. console reset
D. no mgmt-user console-block
An administrator configures a mesh cluster profile and has defined the RF band and cluster name. What else must the administrator configure in the profile?
A. WPA hexkey or passphrase
B. CPSec
C. Mesh portal IP address(es)
D. IPSec
