Which statement is correct about the default configuration of a Mist AP?
A. VLAN tagging is enabled.
B. 192.168.0.1 is statically configured on the uplink port.
C. DHCP is enabled to retrieve IP information.
D. No interface configuration is provided and an IP must be statically defined after booting.
What are two methods of activating a Mist AP? (Choose two.)
A. Use the activation code.
B. Use the claim code.
C. Use the serial number.
D. Use the universal product code.
When using the Mist Cloud with Mist APs, which statement is correct?
A. User data is terminated in the cloud and run through a firewall.
B. User data is compressed and terminated in the cloud.
C. User data is terminated in the cloud and forwarded.
D. User data is bridged locally.
How should you design a WLAN to ensure optimal performance?
A. Place one access point in every room and allow RRM to tune the power and channel settings.
B. Use RF modelling software to design a WLAN to satisfy customer requirements.
C. Initially install 4-8 access points, then use the Mist capacity SLE to determine the remaining access point placements.
D. Place an access point every 8-15 meters in all areas requiring coverage.
What is the base subscription required to get started with a Mist access point?
A. Wi-Fi Management and Assurance
B. Virtual Network Assistant
C. Premium Analytics
D. Mist Edge
You have discovered an access point that is connected to a corporate network, but it is not under the corporation's control.
In this scenario, what is this type of access point called?
A. honeypot
B. air gap
C. rogue
D. neighbor
Marvis requires which subscription?
A. Wired Assurance
B. Asset Visibility
C. Virtual Network Assistant
D. Premium Analytics
What would cause reduced Wi-Fi performance?
A. using 40 MHz channels on 5 GHz
B. using a PSK
C. using a single SSID
D. using too many SSIDs
Which statement is correct about 802.11 wireless network interfaces?
A. Wireless NICs process all frames that are heard.
B. Wireless NICs use Carrier Sense Multiple Access Collision Detection.
C. Wireless NICs operate in full-duplex mode.
D. A wireless NIC only receives frames destined for it.
When would be the earliest opportunity to configure an access point (AP)?
A. after you are on the same network as the AP
B. after the AP is installed
C. after the AP is online
D. after the AP is claimed to inventory
