Which statement best describes the 'config rollback' feature?
A. Once the 'config rollback' feature is enabled; it allows the administrator to re-apply a previously saved configuration file from Flash
B. The 'config rollback' feature is enabled by default; it allows the administrator to re-apply a previously saved configuration file from Flash
C. Once the 'config rollback' feature is enabled; it allows the administrator to re-apply a locked configuration file from a separate area in Flash
D. Once the 'config rollback' feature is enabled; it allows the administrator to revert to the prior ScreenOS image in the event an upgrade operation aborts
E. Once the 'config rollback' feature is enabled; it allows the administrator to revert to the prior ScreenOS image or configuration file in the event an upgrade operation aborts
Which parameter(s) can you modify on a predefined service?
A. protocol timeout
B. source port, destination port and protocol
C. source port range, destination port range, and protocol
D. source IP, source port range, destination IP, destination port range, and protocol
How many Deep Inspection actions can you define in a single policy?
A. 1
B. 2
C. 3
D. 4
E. 5
Which interface is placed in NAT mode to enable interface-based NAT?
A. DMZ interface
B. egress interface
C. ingress interface
D. external interface
You are looking at the event log of the responding device and it says Rejected an initial Phase 1 packet from an unrecognized peer gateway Which is NOT a likely reason for the failure?
A. Peer ID misconfigured
B. gateway address misconfigured
C. Outgoing Interface misconfigured
D. Security proposals misconfigured
You are looking at the event log of the initiating device and it says: Received notify message for DOI <1> <14>
A. Phase 2 PFS failure
B. Phase 1 gateway failure
C. Phase 1 proposal mismatch
D. Phase 2 proposal mismatch
Which is NOT a component of a tunnel interface configuration?
A. zone
B. virtual router
C. subnet mask
D. IP addressing
Which number is used by get event
A. 356
B. 536
C. 563
D. 634
-- Exhibit?
-- Exhibit -Click the Exhibit button to view the exhibit. In order for the 208 to have full reachability to all hosts in the network, how many static routes need to be
added?
A. 1
B. 2
C. 3
D. 4
E. 5
-- Exhibit -
-- Exhibit -Click the Exhibit button.
In the exhibit, you configure NAT-src to translate traffic from the Corporate zone to the Internet zone and
do not specify a DIP.
Which address will be used as the outbound source address?
A. 143.45.56.1
B. 143.45.56.254
C. NAT-src requires a DIP
D. The original source address