You have completed a clustered Data ONTAP installation for a new customer. You are now ready to hand off the system to the customer.
Which three actions should you take at this stage in the installation process? (Choose three.)
A. Show the customer how to open a case with NetApp Support.
B. Demonstrate System Manager and its functionality.
C. Tell the customer to call their sales representative if there are further questions.
D. Tell the customer you are finished and then leave the site.
E. Show the customer how to set up a support account.
According to NetApp, which two scenarios are recommended for a RAID-DP aggregate in clustered Data ONTAP 8.3? (Choose two.)
A. three or more disks if it is a data aggregate
B. three or more disks if it is a root aggregate
C. two or more disks if it is a root aggregate
D. five or more disks if it is a data aggregate
After proper cabling the NetApp CN1610 cluster switches, you notice that joining the second node to a
cluster fails because the node is not able to communicate with the other node.
What would be the reason for this malfunction?
A. CN1610 is unsupported in newer clustered Data ONTAP versions.
B. The NTP server is not set.
C. The FASTPATH version is not supported.
D. The cluster switches must be Cisco switches for two or more nodes in a cluster.
What is a protocol?
A. SnapRestore
B. CIFS
C. SnapMirror/SnapVault
D. FlexClone
A customer is installing a new system and has determined that they have a broken disk.
What information is required to open a NetApp Support case?
A. disk HBA firmware and serial number
B. mainboard rev. id
C. serial number or system ID
D. disk shelf serial number and shelf ID number
Which feature provides preferred protection for the root volume of a storage virtual machine (SVM)?
A. SnapVault
B. load-sharing mirror
C. SnapMirror
D. SyncMirror
What is NetApp's best practice regarding Ethernet flow control?
A. Leave flow control enabled.
B. Disable flow control on the switch ports.
C. Disable flow control on the host, switch, and all node ports.
D. Disable flow control on all 10Gbps ports.
Your customer has four disk shelves attached to an HA pair of nodes running clustered Data ONTAP 8.3. One disk shelf has six SSDs and 18 HDDs installed. They want to know how to partition the SSDs to use them in a flash pool aggregate.
In this situation, what should you tell the customer?
A. Flash pool aggregates must have whole SSDs assigned, not partitions.
B. When the disks are assigned to a storage pool, they are automatically partitioned into four equal parts that can be assigned to an existing aggregate where the partition will be used as flash storage by the assigned aggregate.
C. All SSDs in a mixed disk system are partitioned to a 25% and a 75% partition. The larger partition can be used for data.
D. When the disks are assigned to a storage pool, you can partition each disk into as many partitions as needed. A partition can be assigned to an existing aggregate where the partition will be used as a flash storage by the assigned aggregate.
Which two statements are true regarding SSDs? (Choose two.)
A. SSDs are only available in 400 GB sizes.
B. SSDs must be in different RAID groups than HDDs.
C. SSDs are available for multi-disk carrier shelves.
D. The Maintenance Center is not available for SSDs.
A remote administrator is connecting to a cluster from a different remote network.
According to NetApp best practices, which type of LIF routing is required to accomplish this task?
A. cluster LIF
B. data LIF
C. cluster management LIF
D. intercluster LIF
