You are planning to install a new ONTAP 9.7 All SAN Array (ASA) into your existing data center.
In this scenario, which cluster configuration is allowed with ASA controllers?
A. Add the ASA controllers to an existing 4-node cluster with NAS licenses.
B. ASA controllers can only be added to clusters that have existing SAN licenses.
C. ASA controllers can only be installed as a standalone HA pair.
D. Add the ASA controllers to an existing 10-node cluster.
Click the Exhibit button.
You are setting up a new AFF A700 into a new rack at a customer's site. The customer asks you to plan for simplified future growth.
Referring to the exhibit, how would you satisfy this requirement?
A. Option 4
B. Option 2
C. Option 3
D. Option 1
An ONTAP cluster is installed at a secure site. The array has no access to the Internet but is managed 24/7 by onsite engineers. The customer requires that when hardware failures occur, the failures are reported to the NetApp Support team as quickly as possible.
In this scenario, which two tasks should be performed during the project hand-off procedure to satisfy the customer's requirement? (Choose two.)
A. Ensure that Active IQ Config Advisor is installed.
B. Ensure that the onsite engineers receive EMS alerts when hardware issues occur.
C. Educate the onsite engineers about invoking the AutoSupport tool from ONTAP System Manager.
D. Educate the onsite engineer about how to manually log support calls.
In ONTAP 9.7 software, how many different replicated databases (RDBs) exist per node?
A. 2
B. 5
C. 3
D. 4
Which three components are required when setting up a new ONTAP cluster? (Choose three.)
A. password
B. cluster management IP
C. node management IP
D. Advanced Drive Partitioning
E. intercluster IP
Click the Exhibit button.
You are reviewing the setup of a recently installed FAS9000 switched cluster. As shown in the exhibit, the cluster interconnects are connected to a pair of Cisco Nexus 3132Q-V 40 Gb ports.
For a high availability, which ports should swap Ethernet cables?
A. Swap node1:e8a and node2:e4a.
B. Swap node1:e4a and node1:e8a.
C. Swap node2:e4a and node2:e8a.
D. Swap node1:e4a and node2:e4b.
You want to ensure the highest path resilience and performance increase to the storage stack on your FAS8700 cluster.
In this scenario, which two types of stack cabling are available to use? (Choose two.)
A. quadpath HA
B. mixed-mode
C. single path
D. multipath HA
You install a 4-node cluster with an AFF A400 HA pair and a FAS8300 HA pair. After setup, you are asked to review the audit logs on each controller from a Web browser.
In this scenario, which method provides access to the logs from a Web browser?
A. ACP
B. ADP
C. DNS
D. SPI
Click the Exhibit button.
A customer has two Cisco 40GbE data switches. They want to connect the switches to an AFF A400 HA pair. The switches and the AFF A400 are approximately seven meters apart.
Referring to the exhibit, which two supported actions would allow you to accomplish this task? (Choose two.)
A. Relocate the switches or the AFF A400 so that the distance is less than five meters.
B. Install 10 meter NetApp supported copper cables.
C. Change the requirement for Ethernet cables.
D. Change the requirement for optical cables.
You are installing a new AFF A400 cluster and need to access the cluster management LIF from a remote subnet with the fully qualified domain name (FQDN) a400.lab.netapp.com.
In this scenario, which two network components must be configured to log in to ONTAP System Manager from the remote subnet? (Choose two.)
A. route
B. NTP
C. DNS
D. VLAN
