Click the Exhibit button.
Referring to the exhibit, which SAS connector is supported on the NetApp E2800 E-Series family?
A. 1
B. 4
C. 2
D. 3
A company wants the most scalable host-side connection topology for E-Series systems. In this scenario, which FC topology would satisfy the requirement?
A. direct connect
B. fabric attach
C. private loop
D. arbitrated loop
A customer needs to add an EF280 with FC into its existing Brocade fabric but the FC ports in the SANtricity System Manager are showing the FC ports as down and the LED on the FC HIC is amber.
Which three tasks does the installer need to complete to solve this problem? (Choose three.)
A. Verify that the ports are enabled on the switch
B. Verify that the cables are plugged into the switch
C. Verify that the server HBA has the boot BIOS enabled
D. Verify that the EF280s management port is up E. Verify that the switch zone has the WWPNs for the EF280 and Server HBAs
An administrator is asked to create a Dynamic Disk Pools (DDP) pool from eleven 12 TB disks with the requirement that there is adequate space available for a reconstruction if a drive in the pool fails.
In this scenario, what should the administrator do to satisfy this requirement?
A. Create the disk pool, and then edit the pool to reserve 12 TB of space
B. Create the disk pool, and then add another 12 TB drive to the pool
C. Create the disk pool, and then the system automatically reserves 12 TB of space
D. Create the disk pool, and then create a hot spare on another 12 TB disk
Click the Exhibit button.
Referring to the exhibit, which three steps would you take to solve the problem shown in the event log? (Choose three.)
A. Swap out the SFP in the controller port
B. Swap out the FC cable
C. Reinitialize the FC switch
D. Move the connection to another controller port
E. Swap out the HBA on the FC switch
Which two errors would fail a pre-upgrade health check? (Choose two.)
A. Hot spares are in use
B. Volumes are reported on a non-preferred path
C. An excess number of event log events are present
D. I/O is being processed
You want to find detailed information about the devices that are connected to the Brocade switch. In this scenario, which command would accomplish this goal?
A. portloginshow
B. zoneshow
C. nsshow
D. switchshow
Click the Exhibit button.
A customer's host is running a Red Hat Enterprise Linux 7.6 server with dm-mp configured for ALUA and is connected to a single volume on the EF280 system that is shown in the exhibit.
In this scenario, how many active/optimized paths are available to the volume?
A. 2
B. 8
C. 4
D. 6
You help a customer diagnose a performance issue on an E-Series storage system. You decide to measure the amount of data that is being handled over the span of an hour.
In this scenario, what are you measuring?
A. I/O alignment
B. parity
C. throughput
D. IOPS
A customer is running several EF570 systems and uses the ability of the EF-Series systems to run two host protocols at the same time. You are installing a new EF570 that uses the NVMe protocol for a high performance computing application. The controller on-board ports will not connect, but the HIC ports are working fine.
In this scenario, what is the problem?
A. The on-board host ports are disabled
B. There is a cable fault preventing the on-board ports from connecting
C. The on-board ports have the wrong SFPs for the desired network protocol
D. The switch ports are shut-down